Value Line Discovery Board

Phisatho Fri Oct 28, 2016 2:22 pm

Where can I get the support files for STM32VLDISCOVERY board?
http://www.st.com/en/evaluation-tools/s … overy.html
This board has a STM32F100 chip running at 24MHz with a built-in ST-Link (The ST-Link itself is a STM32F103).

I could not find any pointers from the net.

Replies

ProudPagan Wed Feb 15, 2017 4:52 am

Hello Phisatho,

Could you provide the code that you used? I can compile and what seems like upload the
blinky sketch correctly — see below — but see no blinking LEDs.

STM32 ST-LINK CLI v2.1.0 STM32 ST-LINK Command Line Interface

ST-LINK SN : ST-Link/V1 on E:
ST-LINK Firmware version : V1J11S0 (Need Update)
Old ST-LINK firmware detected!
Please upgrade it from ST-LINK->'Firmware update' menu.
Connected via SWD.
Connection mode : Normal.
Device ID:0x420
Device flash Size : 128 Kbytes
Device family :STM32F100xx Low/Medium density Value Line

Loading file...
Flash Programming:
File : C:\Temp\arduino_build_100163\sketch_feb14a.ino.bin
Address : 0x08000000
Flash memory programming...
±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±±± 0%
0%ÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛ 44%ÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛÛ 89%ÛÛÛÛÛÛ 100%
Flash memory programmed in 1s and 435ms.
Programming Complete.

MCU Reset.

Application started.

nikosx Sun May 07, 2017 5:08 pm

Have tested the Serial2 communication with PC and works OK !! Also analogRead from pin. However DAC -analogWrite- does not seem to work..(program freeze).

nikosx Sun May 07, 2017 5:10 pm

Both board LEDs (green – blue) work OK & User Push switch (also with Interrupt)

dannyf Sun Jun 04, 2017 10:58 am

Where can I get the support files for STM32VLDISCOVERY board?

i’m porting a generic flavor of arduino to ARM chips and this particular board is my stm32 workbench: viewtopic.php?f=42&t=2131

so far, all GPIO, timing, Interrupt, analogRead/Write, UART, hardware SPI/I2C functionalities have been ported over.

RogerClark Sun Jun 04, 2017 10:32 pm

Link spam to your site has been replaced with a link to the discussion on this site.