Spark Logic

Baite Maple Mini connection guide

Baite Maple Mini Baite BTE14-07A wiring guide with power, signal assignments, and bench checks.

Baite BTE14-07A

45 contacts Current package

Baite · This map follows the BTE14-07A PCB. The numbered silkscreen follows the Maple Mini convention. Identify the fitted MCU before selecting the memory layout.

Power the board from USB

Required

Use a single USB cable to power the board through its native connector. Leave external power headers disconnected. Check the 3.3 V rail before attaching the debug probe.

Bench checks

  • Identify the USB power input and ground in the board schematic.
  • Measure roughly 3.3 V between the board logic rail and ground. Check for a short or wrong connector if the rail is low.

Baite BTE14-07A connector map

Connection scenarios

Connect a 3.3 V UART console

Use an external 3.3 V logic-level adapter and keep the board on USB power. Cross transmit and receive, share ground and match the serial framing.

Bench checks

  • Leave the adapter’s supply output disconnected.
  • Enable USART1 on PA9/PA10 and verify that the host receives a known test string.

Baite BTE14-07A connector map

Baite BTE14-07A wiring map

Highlighted contacts are used in the required step or selected circuit. Select a contact to inspect it.

Header 1
Use the board connector marking and locate contact 1 before wiring.
Header 2
Use the board connector marking and locate contact 1 before wiring.
USB connector
Use the board connector marking and locate contact 1 before wiring.
Selected pin details

H2-14 · 25

Configurable I/O · GPIO

Routes to MCU PA10. Choose the applicable GPIO or peripheral function in the MCU documentation.

Baite BTE14-07A connector map

Electrical limits · Pin in the reference

Models and documents

The maps follow the listed PCB variants. Match the board markings and connector positions to the referenced schematic before applying power.

Baite BTE14-07A
This map follows the BTE14-07A PCB. The numbered silkscreen follows the Maple Mini convention. Identify the fitted MCU before selecting the memory layout.