Spark Logic

ILI9163C TFT LCD controller connection guide

ILI9163C TFT LCD controller DT018ATFT · FPC-45 wiring guide with power, signal assignments, and bench checks.

DT018ATFT · FPC-45

45 contacts Current package

ILI Technology ·

Connect the DT018ATFT in 3-wire SPI mode

Required

Use the manufacturer’s 3.3 V 3-wire fixture. Connect the two LED cathodes through separate 130 Ω resistors for a quick illumination test. Use a constant-current driver for normal backlight operation.

R1 130 Ω between LED return 1 and GroundLED return 1R1 130 ΩGround
R2 130 Ω between LED return 2 and GroundLED return 2R2 130 ΩGround

Bench checks

  • Measure 3.3 V at VCC and VDDIO before releasing reset. Confirm the mode straps remain low.
  • Check that the first bit selects command or data and is followed by eight bits. Run the DT018ATFT initialization and verify a 128 × 160 test image.

Displaytech DT018ATFT Rev. 1.0, §§ 5 and 7–9, and SEACOMP DT018ATFT 3-wire SPI connection example. ILI Technology ILI9163C v0.09, interface selection and serial transfer sections, hosted by SEACOMP.

DT018ATFT · FPC-45 wiring map

Highlighted contacts are used in the required step or selected circuit. Select a contact to inspect it.

DT018ATFT · FPC-45
Use the pin-1 marker in the DT018ATFT dimensional drawing and verify the mating connector contact side.
Selected pin details

45 · NC

None · NC / reserved

Reserved contact. Leave open.

Displaytech DT018ATFT Rev. 1.0, §§ 5 and 7–9, and SEACOMP DT018ATFT 3-wire SPI connection example.

Electrical limits · Pin in the reference

Models and documents

The physical map covers the 45-contact DT018ATFT flex cable. On this panel, the manufacturer hardwires the controller’s SPI4 selection, so the documented serial option uses 3-wire framing.

DT018ATFT
Displaytech 1.8-inch 128 × 160 TFT module.