Spark Logic

AT24C08C serial EEPROM pinout

The AT24C08C stores 1024 bytes in four address blocks and supports a full-array hardware write protect input.

SOIC-8

8 contacts Current package
PDIP-8 8 contacts
TSSOP-8 8 contacts
UDFN-8 · 2 × 3 mm 9 contacts
VFBGA-8 · 1.5 × 2.0 mm 8 contacts
SOT-23-5 5 contacts

Microchip Technology ·

SOIC-8 pinout

Top view. Start at the package pin-1 index and follow the numbered leads.
Selected pin details

5 · SDA

Bidirectional · Bidirectional

Open-drain I²C data. The bus needs a pull-up to its logic rail.

Microchip DS20006127A, §§ 1–2, 6–8, 12 and Product Identification System.

Electrical limits · Link to this pin

All 8 pins

PinSignalDirectionFunction
1NC NoneNone No internal connection. Leave electrically open unless the package notes specify otherwise.
2NC NoneNone No internal connection. Leave electrically open unless the package notes specify otherwise.
3A2 InputInput Hardware address bit. Tie to a known logic level. SOT-23 omits this contact and treats it as low.
4GND Supply returnSupply return Connect to the common ground plane or bench return.
5SDA BidirectionalBidirectional Open-drain I²C data. The bus needs a pull-up to its logic rail.
6SCL InputInput I²C clock. Connect to the host clock line with its bus pull-up.
7WP InputInput Tie high to protect the entire array from writes, or low to enable writes.
8VCC Supply inputSupply input Primary device supply. Place the bypass capacitor close to this pin.

Signal assignments

I²C

The two high memory address bits are included in the device address. One word-address byte selects the offset within a block. With A2 low, the four blocks use 0x50–0x53.

Write protection

A logic high blocks writes across all four blocks while allowing reads.

Electrical limits

ParameterLimitConditions and source
Supply1.7–5.5 V1.7–5.5 V See the datasheet timing table for the supported bus clock at the selected supply. Microchip DS20006127A, §§ 1–2, 6–8, 12 and Product Identification System.
Memory1024 bytes1024 bytes Four blocks of 256 bytes. Use the block bits in the device address. Microchip DS20006127A, §§ 1–2, 6–8, 12 and Product Identification System.
Page write16 bytes · 5 ms maximum16 bytes · 5 ms maximum Crossing the end of a page within one write wraps back inside that same page. Microchip DS20006127A, §§ 1–2, 6–8, 12 and Product Identification System.

Models and documents

The six maps follow the package configurations in the Microchip datasheet. Package rows include documented order-code examples. Pin 2 is NC on the 8 Kbit AT24C08C.

AT24C08C-SSHM-B
Bulk package.
AT24C08C-SSHM-T
Tape and reel.